Cleaning The Pre-Filter; Cleaning The Dust Container; Cleaning The Electrobrush/Handheld Brush - Miele Triflex HX1 Cat&Dog SMML0 Operating Instructions Manual

en-US
 Replace the dust container on the
PowerUnit connector.
Cleaning the pre-filter (Fig. 36–39)
The pre-filter is located in the dust con-
tainer.
Clean the pre-filter when required.
 Remove the dust container.
 Remove the fine dust filter (Fig. 35).
 Empty the dust container over a trash
can and lift the pre-filter upwards to
remove it.
 Unlock the motor protection filter by
turning it counterclockwise and lift it
upwards to remove it.

Risk of damage caused by incor-
rect cleaning.
The pre-filter can become damaged
and be less effective as a result.
Do not use pointed or sharp-edged
objects to clean the filter.
 Carefully knock the dust out of the
pre-filter over a bin.
Tip: Use a tool like a fine cleaning brush
to clean the inside of the pre-filter thor-
oughly.
You do not need to clean the motor pro-
tection filter. It can be removed so that
the inside of the pre-filter is easier to
reach.
 After cleaning the pre-filter, place the
motor protection filter back into the
pre-filter securely, making sure it is
properly positioned.
 Lock the motor protection filter by
turning it clockwise as far as it will go.
24
 Replace the pre-filter in the dust con-
tainer.
 To do this, line up the guide lines on
the two sections and turn the dust
container lid back to its original posi-
tion.
 Close the cover at the bottom of the
dust container, making sure it clicks
into place.
 Replace the fine dust filter.
 Replace the dust container on the
PowerUnit connector.

Cleaning the dust container

Clean the dust container as required.
 Remove the dust container.
 Empty the dust container over a
garbage can and lift the pre-filter up-
ward to remove it (Fig. 36).
 Clean the dust container using water
and mild detergent.
 Dry the dust container carefully.
 Reinsert the pre-filter in the dust con-
tainer and turn the pre-filter back to
its original position (Figs. 38 + 39).
 Replace the dust container on the
PowerUnit connector.
Cleaning the Electrobrush/handheld
brush (Fig. 40)
(The availability of the handheld brush
depends on the model)
 Disconnect the Electrobrush/hand-
held brush from the vacuum cleaner
(Fig. 06).