Hitachi DZMV238EAU Service Manual page 61

3) Press the SELECT button and release it, and then, within 0.5 second,
hold down the following 2 buttons for at least 3 seconds to display the
error code (Fig. 3-2a):
SELECT
FOCUS
To restore normal status, press the DISPLAY button.
Caution
Be sure to press the DISPLAY button after the operation is finished.
Since the error code display function is backed up, neglecting to press
DISPLAY will always display the error code.
Details of display:
Error code is displayed in combination of 4 letters and numerals.
The error code of the latest trouble appears in the upper row, and the error
code of the trouble that occurred before (when the content differs from that
of the latest trouble) appears on the lower row.
Each time new trouble that differs from previous ones occurs, the error
codes will be rewritten from the upper row in sequence.
If the following problems occur, the message shown in Fig. 3-2b or 3-2c
will appear on the LCD monitor.
When the self-diagnosis function judges that recovery is not made
even if power is turned on again or the disc is reloaded.
When the same trouble occurs three times consecutively.
3 - 6
Example of error code display
Error code
RAM
STD
12/31/2002
Fig. 3-2a Fig. 3-2a
Error has occurred.
!
Error code No. F9C2
Please read the manual
Fig. 3-2b
(in modes other than recording)
ERROR: F9C2
Fig. 3-2c
(during recording)
F 9 C 2
1 A 2 B
11:59