Error Messages - Sony GY-2120WD Maintenance Manual

6-3-3. Error Messages

When the GY-2120 under the normal operation detects a trouble, the error message is displayed on LCD.
Description of error messages and their remedies are as follows:
("????" is 4 digits of figure, which indicates error code)
Indication
Format? a)
Memory Check Err
REF not Exist
b)
Recover?
[E] Blk Tbl >????
[E] Cp Read >????
[E] Cp Write >????
[E] Data IN >????
[E] Data OUT >????
[E] Dnld Err >????
[E] Drive >????
[E] Fatal >????
[E] Flush >????
[E] Fl/ULD >????
[E] Format >????
[E] Load >????
[E] Mng Tbl >????
[E] Parity >????
[E] PreWrite >????
[E] Read >????
[E] Recover >????
[E] Spc Err >????
[E] Subcode >????
[E] Unload >????
[E] Vol Full >????
[E] Write >????
???? indicates error code
a) Handle error with "FORMAT
(DTF)
b) Handle error with "RECOVER
(DTF)
c) Indicates error which occurred during flashing.
GY-2120WD/WS
Description
A tape which was not formated
Memory check error occurred in GY-2120 start-up.
Error occurred in the internal reference signal when starting GY-2120.
A tape which was not unloaded
Block management table is broken.
Error occured during read operation from tape in copy.
Error occured during write operation on the tape in copy.
Data in phase of SCSI protocol was interrupted.
Data out phase of SCSI protocol was interrupted.
Error occurred during firmware downloading.
Other error occured in GY-2120.
Fatal error occured in GY-2120 (generated system error generate).
Error occured in writing all data in buffer on tape.
Failed in flashing and unloading.
Initialize process was failed in.
(DTF)
Load process was failed in.
(DTF)
Management table became full.
Parity error occured at memory data.
Error happened in write setup process.
Error occured during read operation.
Recover process was failed in.
(DTF)
Error occured during Special Eject.
Subcode area is broken.
Unload process was failed in.
(DTF)
Write operation exceeds the size of current logical volume.
Error occured during write operation.
".
"
is loading.
(DTF)
correctly is loading.
(DTF)
c)
6-3. Error Processing
Remedies
Format a tape.
Replace MEM-83 board
Replace MEM-83 board
Perform recovery.
Judge by error code
(Refer to next page)
6-157