Moving And Installing; Removing The Transit Bolts; Moving The Washing Machine From One Location To Another - Kenwood K814WM18 Installation Instructions Manual

installation

moving and installing

removing the transit bolts

Four transit bolts keep the interior of the washing machine in place while it's being moved.
They need to be removed before installation. Use a spanner (not supplied) and follow the
instructions detailed below.
Don't run the washing machine without removing the transit bolts, as this can cause
excessive vibrations and may damage your machine.
Keep the four (4) transit bolts in a safe
place, in case you need to move the washing machine.
to remove the transit bolts:
1. Ensure the unit is fully disconnected from the mains power by unplugging it from the mains.
2. Unscrew the four (4) transit bolts.
3. They are located at the rear side of the washing machine. Use a spanner (not included) to
loosen the four (4) transit bolts, then pull out the bolts horizontally. Ensure the plastic bolt
guides (if any) are also removed.
4. Snap in the plastic caps to cover the transit bolt holes.

moving the washing machine from one location to another

Before you move the washing machine:
• Shut off the tap and run the washing machine to drain the water. Drain any remaining water
from the pump hose.
• Disconnect the mains cable.
• Attach the transit bolts.
Make sure to fix the transit bolts prior to moving the washing machine.
Kenwood 8kg Washing Machine K814WM18 Manual.indd 9
1
2
4
3
9
21/06/2018 08:12