Table of Contents
Advertisement
DRIVE V-BELT
POWER TRAIN
DRIVE V-BELT (600/700)
WARNING
When installing the new V-belt, make sure
that it is positioned from 1.5 mm (0.06 in)
above the edge of the secondary sheave to
–0.5 mm (–0.02 in) below the edge a .
If the V-belt is not positioned correctly, the
clutch engagement speed will be changed.
The machine may move unexpectedly when
the engine is started.
Adjust the V-belt position by removing or ad-
ding a spacer 1 on each adjusting bolt 2 .
CAUTION:
As the V-belt wears, adjustment may be nec-
essary. To ensure proper clutch perfor-
mance, the V-belt position should be ad-
justed by adding a spacer on each adjusting
bolt when the V-belt position reaches
1.5 mm (0.06 in) below the edge.
New belt width:
34.5 mm (1.36 in)
Belt wear limit width:
32.5 mm (1.28 in)
1. Measure:
S V-belt position a
NOTE:
Install the new V-belt onto the secondary
sheave only. Do not force the V-belt between
the sheaves; the sliding and fixed sheaves must
touch each other.
Standard V-belt height a :
–0.5 X 1.5 mm (–0.02 X 0.06 in)
–13–
INSP
ADJ
Advertisement
Table of Contents
