Yamaha SX500D Supplementary Service Manual page 96

Wire harness
1
Fasten the wire harness with a
2
plastic clamp.
Route the wire harness through
the slot on the intake silencer.
CDI unit and ECU
3
Fasten the wire harness with a
4
plastic clamp.
Route the wire harness through
the slot on the intake silencer.
Carburetor switch coupler
5
Water temperature sensor coupler
6
Starter relay coupler
7
CDI unit
8
Make sure a plastic-locking tie is
9
routed through wire harnesses
as shown.
Fasten the fuel hose at the white
10
paint mark.
To the carburetor
11
CDI unit coupler
12
To the carburetor
13
CDI magneto coupler
14
CDI unit coupler
15
CABLE ROUTING
–92–
SPEC