Names And Operations - Panasonic CZ-RWSU3U Operating Instructions Manual

2. Names and Operations

REMOTE CONTROLLER
1. Operation Display
Displays the operation status.
(The figure shows all the possible
segments that may appear on the
display.)
• The auto-flap display may be
different depending on the
installed unit. (See page 14.)
2. Start/Stop button
Pressing this button once starts
and pressing again stops the
operation.
3. Fan speed button
4. Swing/Wind Direction button
5. Timer setting button
Use for operating with a timer.
6. RESET button
Use this button after changing the
batteries.
7. Cover
Press at the top center and then
slide down.
8. Transmitter
9. Remote control sensor
Detects the temperature at the
remote controller when detection
has been switched to the remote
controller by the SENSOR button.
10. Temperature setting buttons
raises the temperature
setting.
lowers the temperature
setting.
One remote controller can control a group of
up to eight indoor units. (See page 15)
11. Filter button
CZ-RWSC3
Press to turn off the filter lamp on
the receiver.
12. Mode Select button
Press to switch the operation
mode.
13. Ventilation button
Use this when connected to an
aftermarket fan. Pressing this
button starts and stops the fan.
When the air conditioner is started
or stopped, the fan starts or stops
at the same time. (
the display of the remote
controller when the fan is
operating.)
14. Address button
15. SENSOR button
Used this to activate the
temperature sensor on the remote
controller instead of the one on
the indoor unit.
The temperature sensor on the
indoor unit is selected at
shipment. At this time
on the display.
16. Clock button
Use this to set the clock.
From this page, the names of
remote controller's buttons will be
indicated with the above
illustrations.
E.g.: Start/Stop button 
appears on
is shown
6
(EN)