Advertisement
Quick Links
FP-F40E
FP-F40L
"Plasmacluster" and "Device of a cluster of grapes" are
trademarks of Sharp Corporation.
*The number in this technology mark indicates an
approximate number of ions supplied into air of 1 cm
which is measured around the center of a room with
the "high-density plasmacluster 7000" applicable floor
area (at 1.2 m height above the floor) at the medium
wind volume in air purifying mode, when an air purifier
using the high-density plasmacluster ion evolving
device is placed close to a wall. This product is
equipped with a device corresponding to this capacity.
Free standing type
Jenis berdiri sendiri
站立式
R
AIR PURIFIER
OPERATION MANUAL
PEMBERSIH UDARA
BUKU PANDUAN OPERASI
空气净化器操作手册
,
3
Advertisement
Related Manuals for Sharp FP-F40E
Summary of Contents for Sharp FP-F40E
- Page 1 BUKU PANDUAN OPERASI 空气净化器操作手册 “Plasmacluster” and “Device of a cluster of grapes” are trademarks of Sharp Corporation. *The number in this technology mark indicates an approximate number of ions supplied into air of 1 cm which is measured around the center of a room with the “high-density plasmacluster 7000”...
- Page 2 Please read before operating your new Air Purifier The air purifier draws in room air from the air intake, passes the air through a Pre- Filter, a Deodorizing Filter and a HEPA Filter inside of the unit, then discharges the air through the air outlet.
-
Page 3: Table Of Contents
Sensor Technology continuously monitors air quality, and automatically adjusting operation based on detected air purity. Thank you for purchasing the SHARP Air Purifier. Please read this manual carefully. Before using this product, be sure to read the section: “Important Safety Instructions.”... -
Page 4: Important Safety Instructions
• Be cautious when cleaning the unit. Corrosive cleansers may damage the exterior. • Only a Sharp Authorized Service Centre should service this air purifier. Contact the nearest Service Centre for any problems, adjustments, or repairs. - Page 5 CAUTIONS CONCERNING OPERATION • Do not block the intake and/or air outlet. • Do not use the unit near or on hot objects, such as stoves or heaters or where it may come into contact with steam. • Do not lay the unit down when using. •...
-
Page 6: Part Names
PART NAMES FRONT DUST SIGN Indicates the air purity of the room in 3 levels with color changes. Green Clean PLASMACLUSTER SIGN Orange blue Plasmacluster ON Impure Plasmacluster OFF BACK Main Unit Dust sensor / Dust Sensor Filter Air Outlet HEPA Filter OFF TIMER Button / Deodorizing Filter... -
Page 7: Filter Installation
FILTER INSTALLATION Be sure to remove the power plug from the wall outlet. To maintain the quality of the filter, it is installed in the main unit and packed in plastic bag. Be sure to remove the filter from the plastic bag before using the unit. Replace the Back Panel to the Remove the Back Panel. -
Page 8: Operation
OPERATION CLEAN AIR START STOP • Select the desired fan speed. • Unless the power cord has been unplugged, the operation starts in the previous mode it was operated in. HAZE The unit operates at HIGH fan speed for 60 minutes and then alternates between Low and High level for 20 minutes each. - Page 9 OFF TIMER Select the length of time you want, with the unit on. The unit automatically stops once the selected time is reached. CANCELLATION Light Control You can set the DUST/PLASMACLUSTER SIGN to OFF when their SIGN is bright. NOTE •...
-
Page 10: Care And Maintenance
CARE AND MAINTENANCE To maintain optimum performance of this air purifier, please clean the unit including the filter periodically. Be sure to disconnect the power cord from the wall outlet before performing any maintenance. BACK PANEL (Pre-filter) Gently remove dust from the back panel, using a vacuum cleaner attachment or similar tool. - Page 11 Be sure to remove the power plug from the wall outlet. FILTER REPLACEMENT GUIDELINES Replacement timing About 2 years after operating Do not wash and reuse the filter The filter life and replacement period are based on the condition of smoking 5 cigarettes per day and the dust collection power is reduced by half compared with that of new filter.
-
Page 12: Troubleshooting
TROUBLESHOOTING Before calling for service, please review the Troubleshooting chart below, since the problem may not be a unit malfunction. SYMPTOM REMEDY (not a malfunction) Odours and smoke are not • Replace the filters if they appear to be heavily soiled. (Ref. -
Page 13: Specifications
SPECIFICATIONS Power supply 220-240V 50-60Hz Fan Speed Adjustment SLEEP Speed Rated Power 3.7~5.9W Operation Fan Speed 240m /hour 150m /hour 48~90m /hour Recommended Room Size ~30m 2 *2 High density Plasmacluster ion recommended room size ~23m 2 *3 Cord Length 2.0m Dimensions 383mm(W)x209mm(D)x540mm(H)