2 ] Unpacking And Installation - Sharp AR-FN3 Service Manual

[2] UNPACKING AND
INSTALLATION
1. Unpacking
Refer to the sketch below for unpacking.
2. Installation
Unplug the copier's power cord before carrying out
the following procedure.
1. Attach the lock plate and mounting plate.
Remove the two screws from the upper left cabinet of the copiery and
attach the lock plate to the upper left cabinet using two screws D.
Lock plate
Screws D
2. Attach the mounting plate.
Cut out the two mounting holes (the leftmost hole and the third hole
from the left) at the lower part of the desk using a Phillips screwdriver,
etc., and remove the burrs using a flat-blade screwdriver, etc.
Then, attach the mounting plate to the lower part of the desk using
two screws A.
Screws A
3. Attach the connecting plate to the finisher.
Insert the connecting plate into the lower part of the finisher and
attach the plate at the position with mark B using screw B.
Screw B
2 – 1
AR-FN3
Screws for upper
left cabinet
Mounting hole
Mounting plate
Connecting plate
9/2/1999