GENERAL INFORMATION ABB con rms the tool described in this instruction manual complies with the basic safety and health requirements of EC Machinery Directive 2006/42/EC and EMC Directive 2004/108/EC relating to electromagnetic compatibility. FEATURES WARNINGS &...
PARTS AND ACCESSORIES CHARGER BATC-230 HYDRAULIC COMPRESSION TOOL (B-CK 240) Air Vent Air Vent Air Vent LED Lamp BATTERY BAT-LI34 Work Light Work Light Work Light Button Advance Release Trigger Button CARRYING CASE OPTIONAL POWER SUPPLY (POWER-230) SOLD SEPARATELY Hanging Strap...
OPERATING INSTRUCTIONS CHARGING THE BATTERY 1. Connect the power cord of Charger BATC-230 to a 230V 50Hz outlet. The Left LED Lamp Illuminates Red [STAND BY]. 2. Insert the Battery rmly into the charger. The Right LED Lamp Illuminates Green [CHARGING]. NOTE: Do not short-circuit the Charger by placing foreign materials in the contacts on Charger, as this will damage the Charger and expose the user to potential safety hazards.
COMPRESSION OPERATION 1. Retract the Ram fully by pressing the release button (see Step 3.3). WARNING 2. Open the tool head by lifting the Latch (Figure 1). Pinch point hazard. Compression Dies at high force can cause severe personal injury. Keep 3.
TROUBLESHOOTING Problem Cause Solution The battery is not charged or defective. Charge or replace the battery. There is dust or foreign objects lodged at Remove foreign objects. The motor does not operate at all. the battery contacts. Check to see if switch is aligned with trigger, The switch is misaligned.