Brother 1034D Serger Quick Reference Manual
Hide thumbs
Also See for 1034D Serger:
- Handbook (68 pages) ,
- Handboek voor de compacte (68 pages) ,
- User manual (25 pages)
Related Manuals for Brother 1034D Serger
Summary of Contents for Brother 1034D Serger
- Page 1 Brother 1034D Serger Quick Reference Guide Threading You will thread one spool at a time. You must thread the machine in the correct order.
- Page 2 Brother 1034D Serger Quick Reference Guide Remember, some stitches use all 4 spools, but some use 2. Place spools of thread on the spool pins, and place only three spools. Refer to the Serger Techniques thread spool caps on top of spools. If you are using booklet for detailed information on stitches.
- Page 3 Brother 1034D Serger Quick Reference Guide Spool #1 (The Upperlooper) 3. Pull the thread left and, using the tweezers, insert the thread through the hole on the metal arm that extends 1. Repeat steps 1-3 for Spool #1. left toward the needles.
- Page 4 Brother 1034D Serger Quick Reference Guide 3. Continue down through the groove past the “4”. Spool #2(The Lowerlooper) 4. Follow the blue line to the hook next to the blue number “5”. Pull left from the hook through the two 1.
- Page 5 Brother 1034D Serger Quick Reference Guide 5. Next, pull the white lever with blue arrows all the way 6. Once thread is wrapped around prong, push the white to the right. Hook the thread around the prong on the lever in all the way back to the left until it clicks.
- Page 6 Brother 1034D Serger Quick Reference Guide 7. Using the tweezers, guide the thread through the small hole on the metal hook just above the white 8. Pull the thread under the presser foot and behind. lever. TWEEZERS Thread goes through here...
- Page 7 Brother 1034D Serger Quick Reference Guide Spool #3 (The right needle) 3. Guide the thread up through the groove with the number “5.” 1. Repeat steps 1-3 for Spool #1. 2. Pull thread down in groove past the number “4,” then pull left.
- Page 8 Brother 1034D Serger Quick Reference Guide 5. Slide the thread behind the metal hook just above the 6. Using tweezers, insert the thread through the needle needles. on the right. 7. Pull the thread under the presser foot and behind.
- Page 9 Brother 1034D Serger Quick Reference Guide Spool #4 (The Left Needle) 4. Then pull down towards the needles. 1. Repeat steps 1-3 for Spool #1. 2. Pull thread down in groove past the number “4,” then pull left. 3. Go up and around the arched groove marked with the number “5.”...
- Page 10 Brother 1034D Serger Quick Reference Guide Removing/Replacing the Needles 2. Grab the needles between your thumb and forefinger and pull down and out. 1. Using the hexagonal wrench from the supplies bag, loosen the small screw directly above the needles.
- Page 11 Brother 1034D Serger Quick Reference Guide Side Knobs Differential Feed Adjustor Lever – controls the movement of the front and rear feed sSStitch Width Control – dogs. Higher adjusts the width of numbers (1 - 2) will stitches from R4.5mm to gather or push 7mm.