Panasonic MK-5086M Operating Instructions Manual page 7

How to Use
使用方法
Using the Knife blade
使用葉刀片時
Match the ▼ mark on the bowl with projected detent on the
1
motor housing, and turn the bowl counterclockwise.
將容器上▼標記與馬達箱罩上的鎖銷對齊，沿轉軸套入容器。
沿逆時針旋緊之。
mark
標記
Projected
detent
鎖扣
Fit the knife blade, then put the ingredients into the bowl.
2
See "Preparations for Ingredients" on P.8 - P.9.
裝好葉刀片後，將材料放入容器。參閱"材料準備"第８﹣
９頁）加料。
Match the ▼ mark on the cover with the ▲ mark on the
3
handle. Turn the cover counterclockwise completely (until
'click' sound is heard).
把在蓋罩上的▼標志對准于在把柄上的▲標志，然后把蓋罩
完全地逆時鐘地轉 (直到｀喀嚓'聲)。
Plug in and switch on.
4
插入電源插頭，按下ON按鈕。
12
How to Use
使用方法
When processing is completed, switch off and unplug.
Take off the cover and remove the knife blade.
攪拌處理結束後，按下OFF按鈕，拔去電源插頭。
Remove the bowl and take out the ingredients.
提出容器，取出加工好的食物。
• Cut the food into small pieces.
• Do not put hot ingredients (over 60ºC) in the bowl.
• If the cover is not closed completely (until 'click sound), the switch will not work.
• Before removing the cover, make sure the knife blades have completely stopped.
• If the knife blade becomes clogged with ingredients, switch off the unit, and unplug the power cord. Then
remove the ingredients. Clear the clogged ingredients and resume cutting.
• The motor housing may sometimes vibrate. Hold the motor housing with hand during operation.
• Do not place the unit on wet surfaces.
•葉刀片用於攪切食品材料為碎粒加工。
•切勿用其攪切溫度超過60ºC的材料。
•蓋罩沒完全蓋好（直到｀喀嚓' 聲)，開關將無法啟動。
•打開蓋罩前，請先確認葉刀片已完全停止轉動。
•葉刀片轉動食品材料塊堵塞時，關閉本機，關閉電源然後將電源插頭拔出。取出阻礙的材料塊然後再繼續之。
•有時，加工時馬達箱罩的振動較強烈。這時，請用手按住馬達箱罩再按ON按鈕。
•切勿將加工器置於潮濕的表面。
13