Control Wiring - Sony VPL-FE100U Series Quick Start Reference Sheet

Hide thumbs Also See for VPL-FE100U Series:

SmartPanel Projector Driver Application Note

II. CONTROL WIRING

PROJECTOR CONTROL

RS232

5 4 3 2 1

Male DB9

9 8 7 6

RS-232 to the port labeled

RS-232C/422A

This section specifies how RS-232 should be wired to the

projector.

RS-232 should be connected to the control port labeled RS-

IR/SERIAL

232C/422A. Connection should be as follows:

1. Wire the Panel to a male DB9 as follows:

2. Connect the cable to the projector port labeled RS-

Wired Remote /

232C/422A.

Infrared do not

have to be wired

for this projector.

3. Optionally, an intermediate cable (male DB9 to female

DB9) may be used to facilitate service to the projector

or Panel.

NOTE:

Be sure the hardware switch labeled

RS-232C RS-422A

is set to RS-232C (to the left) or the projector will not

respond to control properly.

TX to 2

RX to 3

GND to 5

Sony VPL-FE100U

help@spcontrols.com

Table of Contents