Audio Settings - Panasonic TY-FB30DHD3D Operating Instructions Manual

Settings

Audio Settings

By installing this terminal board in a compatible display, its audio settings can be performed by the display.
(For details on the display method, setting method, etc., see the instruction manual for the display unit.)
In the Sound menu of the Display
SDI Sound Output
Left Channel
Right Channel
Sound Out
Level Meter
Level meter display
1ch 9ch
10ch
2ch
11ch
3ch
12ch
4ch
1-8ch 9-16ch
Notes:
• Regarding the audio signal by this board, only the multiplexed and stored signal in the HD-SDI/Dual Link HD-SDI
Link A/3D Dual HD-SDI 1(L) input signal is output.
• Under any of the following conditions, audio signal output is suspended.
Signals other than listed under "Audio signals supported by this board" are input
A channel that has not been multiplexed and stored in the SDI signal is selected
Output will be suspended if either output channel (L/R) is selected.
3D settings
By mounting this board on a compatible display, 3D images can be displayed.
(For details on the setting method, see the instruction manual for the display unit.)
<On the display's Setup - 3D Settings menu>
Setup
3D Settings
Signal
Screensaver
Extended life settings
Input label
Component/RGB-in select
Power save
Standby save
PC Power management
DVI-D Power management
No signal power off
No activity power off
English ( UK )
OSD Language
3D Picture Display: 3D: 3D images correspond to the 3D image signal.
3D Picture Format: Simultaneous: Set this format when simultaneous L/R is input to this board.
24
2/2
Channel 1
Channel 2
On
Off
-20 dBFS (0 dB)
Shown above is a screen display for 1-8ch
and 9-16ch.
1/2
press
RGB
Off
On
Off
Off
Disable
Enable
Side by Side/Top and Bottom:
Set this format when this format signal is input to this board.
Left Channel : Selects the SDI audio channels whose signals are
to be output to the left channel of the display
Channel 1 to Channel 16 (Initial setting: Channel 1)
Right Channel: Selects the SDI audio channels whose signals are
to be output to the right channel of the display
Channel 1 to Channel 16 (Initial setting: Channel 2)
Sound Out : Sets the SDI audio output On or Off
(Initial setting: On)
Level Meter : Displays the SDI audio level meter
Off, 1-8ch, 9-16ch (Initial setting: Off)
0 dBFS
3D Settings sub-menu screen
3D Settings
3D Picture Display
3D Picture Format
3D Picture Sequence
Safety Precautions
5ch 13ch
14ch
6ch
15ch
7ch
16ch
8ch
1-8ch 9-16ch
3D
Auto
Normal