Installing The Colorburst Rip Server Software For Windows - Epson Stylus Pro 4000 User Manual

Note: The Windows RIP
server software supports
printing from Windows
XP and Windows 2000
client computers only. To
print with both Macintosh
and Windows clients, you
must install the RIP
server software on a
Macintosh server.
See page 7.
Installing and Setting Up the Server Software
If you will be printing from other computers on the network, install the
client PPDs and set up the clients for printing. See "Setting Up Client
Systems" on page 21.
For details on managing print jobs, see page 39.
Installing the ColorBurst RIP Server Software for
Windows
Before you begin, make sure you have:
Set up the Epson Stylus Pro 4000 and installed the standard Epson
•
printer driver on the computer you intend to use as your ColorBurst
RIP server (see your Epson printer documentation for instructions)
Connected the printer to the server using the USB interface
•
(recommended method) or connected the printer to an Ethernet
network and assigned it an IP address (see the documentation that came
with the included network card) and that you are able to print from the
standard driver
Closed all open programs and turned off any virus protection programs
•
Follow these steps to install the server software:
1. Insert the ColorBurst RIP CD-ROM into your drive.
2. Double-click the
3. Follow the on-screen instructions to install the
ColorBurst RIP.
4. When you see the message "Digital Signature Not Found," click
continue the installation.
5. Restart your computer.
6. Go to >
Start Settings
7. Right-click the ColorBurst RIP printer icon and choose
.
Properties
ColorBurst Epson Installer
> (or
Printers
15
icon.
>
Start Printers and Faxes
| 15
to
Yes
).