Toro 38701 Operator's Manual page 27

Checking the Condition of the
Belts
Service Interval: Every 50 hours
1. Remove the belt cover; refer to
Belt Cover (page
2. Check the 2 belts for damage or wear.
Note:
Replace damaged or excessively worn
belt(s); refer to Replacing the Broom Drive Belt
(page 27) and Replacing the Traction Belt (page
28).
3. Install the belt cover; refer to
Cover (page 26).
Replacing the Broom Drive Belt
Removing the Broom-Drive Belt
1. Park the machine on a level surface, shut off the
engine, and wait for all moving parts to stop.
2. Remove the belt cover; refer to
Belt Cover (page
3. Remove the 2 flange capscrews that secure
the belt guide, and remove the guide from the
engine (Figure 44).
Important:
Do not bend the belt guide while
removing it.
Removing the
26).
Installing the Belt
Removing the
26).
1. Belt guide
2. Flange capscrew
3. Broom-drive pulley
4. Flat washer
4. Remove the capscrew (3/8 x 2 inches) and
washer that secures the broom-drive pulley to
the crankshaft of the engine, and remove the
pulley (Figure
Note:
If necessary, hold the pulley spacer
between the broom-drive pulley and engine to
keep the crankshaft from turning.
You do not need to remove the pulley spacer
from the crankshaft.
5. Slip the broom-drive belt 96 cm (37-1/4 inch) off
the driveshaft pulley, and remove the belt from
the machine.
27
Figure 44
5. Capscrew (3/8 x 2 inches)
6. Pulley spacer
7. Broom-drive belt 96 cm
(37-1/4 inch)
44).
g326318