Toro 38701 Operator's Manual page 29

Figure 47
1. Flange-head capscrew
(1/4 x 5/8 inch—loosen)
2. Bottom cover
3. Flange-head capscrew
(1/4 x 5/8 inch)
6. Remove the 6 flange-head capscrew (1/4 x
5/8 inch) that secure the bottom cover to the
machine, and remove the cover
7. Slip the traction belt between the friction wheel
and the traction pulley, and remove the belt from
the machine (Figure
Figure 48
1. Friction wheel
2. Traction belt
Installing the Traction Belt
1. Slip the traction belt between the friction wheel
and the traction pulley, and into the machine
(Figure 49).
4. Flange (side plate)
5. Rear cover
(Figure 47).
48).
3. Traction pulley
g326387
1. Friction wheel
2. Traction belt
2. At the top of the machine, align the traction belt
into the groove of the traction pulley, and slip the
traction belt over the crankshaft of the engine
(Figure 50).
1. Sheave half
2. Traction belt 87.6 cm
(34-1/2 inches)
3. Pulley spacer
g326386
3. Install the broom drive belt; refer to
Broom Drive Belt (page
4. At the bottom of the machine, align the holes in
the bottom cover with the holes in the flanges of
the left and right side plates
Note:
Ensure that the rear cover overlaps the
bottom cover.
29
Figure 49
3. Traction pulley
Figure 50
4. Shaft spacer
5. Crankshaft (engine)
Installing the
28).
(Figure 51).
g326389
g326388