Advertisement
5. Removal of the gear holder
(1) Pull out Connecting Piece (A) [33] and Needle Bearing [34] from the Gear [36].
(2) Remove the Retaining Ring for D7 Shaft [35] from the tip of the spindle.
(3) Remove the Gear [36], Balance Weight [37], Orbital Cam [38] and Washer (A) [23] in this order.
(4) Remove the Motor [13] press-fitted in the Gear Holder Ass'y [47].
(5) Remove the Retaining Ring (E-type) for D5 Shaft [39], Change Knob [42], Spring (C) [27], and Steel
Ball 5/32 [41].
NOTE: Be careful not to lose Spring (C) [27] and Steel Ball 5/32 [41].
(6) Pull out the Needle Roller D4 x 24 [40] press-fitted in the Gear Holder Ass'y [47]. Remove the Roller
Holder [49] and Needle Roller [48].
Fig. 5
[33]
[34]
[35]
[37]
[36]
[38]
[39]
[41]
[27]
[42]
[40]
[13]
[23]
[46]
[47]
[48]
[49]
-3-
Advertisement
