Summary of Contents for Fujitsu PRIMERGY RX1330 M4
Page 1
When the power is connected to the PRIMERGY server, the system tries to start before the Fujitsu Integrated Remote Management Controller (iRMC) is ready. This is indicated by the fans speeding up to the maximum as soon as the power is connected. The iRMC takes about two minutes to boot up, then you see the display on the screen indicating POST and the fans slow down to normal speed.
Page 2
2. Open the housing and locate the jumper block for UEFI Recovery (RCVR) / Password Clear (PWD CLR) Consult the relevant PRIMERGY Maintenance Manual from http://manuals.ts.fujitsu.com for help to open the housing The board schematic sticker on the inside can guide to the location of the RCVR/PWD CLR jumper block ...
Page 3
PRIMERGY CUSTOMER INFORMATION BULLETIN warning message will be displayed indicating the jumper is placed in a password clear position. 5. Enter UEFI (BIOS) setup, go to ‘Save and Exit’ tab and choose ‘Save Changes and Reset’ 6. Disconnect the power cables 7.