Advertisement
Install the Device/ 设备安装
A Install the SD card/ 安装 SD 卡
Use the Phillips screwdriver to remove the camera bottom cover, face the side of the SD card with pins towards
the board, and insert the SD card. During SD card installation, you are advised to face the camera maintenance
window downward and insert the SD card into the SD card slot from bottom to top to prevent the SD card from
falling inside the camera.
使用十字螺丝刀将摄像机底盖卸下， 将 SD 卡有管脚的一面朝单板方向， 插入 SD 卡。 安装 SD 卡时， 建议将摄像机维护窗朝下，
将 SD 卡从下往上插入 SD 卡槽。避免不慎将 SD 卡掉入摄像机内部，造成设备故障。
Put the camera tails through the central hole on the pole-mount bracket, connect the cables to the tails of
2
the camera, perform insulation and waterproof operations on the cables (see Connect Cables), fix the tails,
and fasten the M4 screw into the hole marked with 5.
将摄像机尾线穿过柱装支架中心圆孔， 将线缆与尾线连接， 对线缆进行绝缘和防水处理 （参见 "连接线缆" ） ， 并固定尾线。
选择编号为 5 的螺口，拧紧 M4 螺钉。
B Pole-Mount（without connection box）/ 抱装（不带接线盒）
1
NOTE/ 说明
• When the camera is not connected
or cannot be connected to a video
surveillance platform for a long time, you
are advised to disable video buffering of
the camera to increase the service life of
the SD card.
若摄像机长时间无法接通平台或者不对接
平台使用，建议手动关闭摄像机的平台离
线缓存补录功能，以提高SD卡的使用寿
命。
• For details, see the Configuration
Guide.
详细操作请参见《配置指南》。
3
Unfasten the two loops and put the loops through the installation holes on the pole-mount bracket. Place the
loops around the pole and fasten the loops to fix the pole-mount bracket on the pole.
将 2 个抱箍拧开，穿过抱装支架的安装孔。将抱箍环绕在立杆上，拧紧抱箍，将抱装支架固定在立杆上。
Unfasten the three hex socket screws, adjust the camera to the required surveillance angle, and fasten the hex
socket screws.
拧松支架的 3 个内六角螺钉，调整摄像机监控角度至所需位置，再拧紧内六角螺钉。
NOTE/ 说明
After adjusting the camera's surveillance angle, if the image still blurs due to out-of-synchronization of
the lens after automatic or manual focus, log in to the IPC web page, and click the
lens. For details, see the Configuration Guide.
调整完毕后，在自动对焦或者手动聚焦后图像仍然模糊（由镜头失步引起的虚焦），请登录Web页面，单击
位镜头，具体请参见《配置指南》。
icon to reset the
复
Advertisement
