Procedure - Huawei APAA00001 User Manual

APAA00001
User Manual
Figure 3-2 ALD control over the OOK port

3.3 Procedure

Step 1 Select the networking drawing for cable connection based on the ALD capability.
Step 2 Power on the PAA. When the power indicator is steady on, the PAA is powered on properly.
If the PAA cannot be powered on, recharge the PAA by using the AC/DC adapter of the PAA.
When the PAA is being recharged, the power indicator blinks.
Step 3 Open the PAA app on the smartphone and then perform bluetooth pairing based on the
displayed messages. The bluetooth device name of the PAA consists of PAA and the last
eight characters of the bar code labeled on the back of the PAA. The bluetooth password is
Draft A (2015-06-12)
 The total length of the RF cable cannot exceed 50 m.
 Connectors and cables can be used for transfer during cable connection.
 The external power supply switch of the PAA must be turned on when the ALD is connected. Figure
3-4 shows the external power supply switch of the PAA.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 Networking Guideline
12