Networking Guideline; Before Network Deployment; Typical Scenarios; Ald Control Over The Aisg Port - Huawei APAA00001 User Manual

APAA00001
User Manual

3.1 Before Network Deployment

Before using the PAA, ensure that the following preparations have been made:



The mode in which the PAA controls an ALD depends on the ALD capability.




3.2 Typical Scenarios

3.2.1 ALD Control over the AISG Port

The AISG output port on the PAA is connected to the AISG input port on the ALD using an
AISG cable, as shown in Figure 3-1.
Draft A (2015-06-12)
3
The AISG cable or RF cable has been connected to the ALD.
The PAA app has been installed properly.
The battery inside the PAA is fully charged. If no, recharge the PAA or connect the PAA
to the power adapter.
If the ALD supports only the RS485 control mode, the PAA controls the ALD over the
AISG port. For details, see section 3.2.1 "ALD Control over the AISG Port."
If the ALD supports only the OOK control mode, the PAA controls the ALD over the
OOK port. For details, see section 3.2.2 "ALD Control over the OOK Port."
If the ALD supports both OOK and RS485 control modes, the PAA selects the control
mode based on actual situations.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.

Networking Guideline

3 Networking Guideline
10