Connect The Scanner - Epson Perfection 3200 Start Manual

3

Connect the Scanner

After your software is installed, it's time to get connected.
1
Remove the sticker from the transportation lock. Use a coin to turn
the lock clockwise one-quarter turn to unlock the scanner carriage.
2
Remove the sticker from the back of the scanner.
Remove sticker
3
Connect the cable for the built-in transparency unit to the round
connector on the back of the scanner. You may need to raise the
scanner cover and twist the cable to insert it.
4
Connect either the USB interface cable that comes with your scanner
or an optional IEEE 1394 (FireWire) cable. Don't connect both.
If you're using USB...
Plug the
USB port. Then plug the
on your computer or USB hub.
Note: Your scanner may not work correctly if you use a USB
cable other than the one supplied by EPSON or if you
connect your scanner to a multi-level USB hub system.
If you're using IEEE 1394 (FireWire)...
Plug one end of the IEEE 1394 cable (not included) into the scanner's
IEEE 1394 port. Then plug the other end into the IEEE 1394 (FireWire,
iLink) port on your computer.
5
Plug the scanner's power cord into a grounded electrical outlet.
6
Press the
The scanner lamp comes on.
square end of the USB cable into the scanner's
power button on the front of the scanner to turn it on.
Make sure the
arrow faces up
flat end into any available USB port