HP ENVY x360 Convertible Maintenance And Service Manual page 38

4. Pry the two screw covers from the middle of the bottom cover (3).
Rubber feet and rubber screw covers are available in the Rubber Kit, spare part number 807533-001.
5. Remove the 12 Phillips PM2.5×6.0 screws that secure the top cover to the computer.
6. Position the computer upright, and then open the computer as far as possible.
7. Starting on the inside above the keyboard near the hinges, pull up at the seams to disengage the cover
from the computer (1), far enough to access the keyboard and touchpad connectors on the system
board.
NOTE:
system board. Be sure not to pull the cables loose when lifting the top cover.
28 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
When you lift the top cover, the keyboard cable and the touchpad cable are connected to the