Table of Contents
Advertisement
2.9 Your fax number (KX-MB2025/
KX-MB2030 only)
You can program your fax number so that it appears on
the top of each page sent.
MRecallN
1
MMenuN A MBNM1NM0NM3N A MSetN
2
Enter your fax number, up to 20 digits.
R To enter a "+", press MGN.
R To enter a space, press MBN.
R To enter a hyphen, press MRecallN.
R To erase a number, press MStopN.
3
MSetN
4
Press MMenuN to exit.
To correct a mistake
Press MFN or MEN to move the cursor to the incorrect
number, and make the correction.
R To erase all numbers, press and hold MStopN.
MMenuN
MStopN
MSetN
MFNMEN
2.10 Configuring the unit to
access the LAN (KX-MB2000/
KX-MB2010/KX-MB2030 only)
You can print documents, scan documents, receive
faxes or send faxes (KX-MB2030 only) using a computer
connected to the LAN. To enable these features, you
need to set the IP address, subnet mask, and default
gateway in the unit.
Important:
R Consult your network administrator when setting
the IP address, subnet mask, and default
gateway.
2.10.1 Setting up automatically with a DHCP
server
Your situation:
– When only one unit is connected to the LAN.
If your network administrator manages the network with
a DHCP (Dynamic Host Configuration Protocol) server,
it will automatically assign an IP (Internet Protocol)
address, subnet mask, and default gateway to the unit.
1
After connecting the LAN cable to the unit and the
computer, turn the power switch ON.
R The IP address, subnet mask, and default
gateway will be set automatically.
2
Install Multi-Function Station on the computer that
you want to use it with. See page 24 for details.
Note:
R You can connect two or more units and assign IP
addresses automatically with a DHCP server, but we
recommend assigning static IP addresses manually
for each unit to avoid network access and
configuration troubles.
2.10.2 Setting up manually
Your situation:
– When your network administrator does not manage
the network with a DHCP server.
– When two or more units are connected to the LAN.
You need to assign an IP address, subnet mask, and
default gateway manually.
1
MMenuN
2
Press MBNM5NM0NM0N to display "DHCP".
3
Press M0N to select "DISABLED". A MSetN
4
Set each item.
For the IP address:
1. Press M5NM0NM1N to display "IP ADDRESS". A
MSetN
2. Enter the IP address of the unit. A MSetN
2. Preparation
23
Advertisement
Table of Contents
