Fujitsu SK-96380-120PMC User Manual page 28

5.1.3 Reset (optional)
Depending on the programming software a reset signal might be generated by RTS or DTR
line. In order to use this optional feature additional jumper have to be set:
Jumper Programming
JP23
UART0
(DTR/RTS)
JP38
UART2
(DTR/RTS)
JP33
UART0 or
UART2
(RESET A/B)
JP41
UART0 or
UART2
(DTR / DTRx)
5.1.4 Flash Programming
1) Configure the microcontroller mode:
(Programming Mode)
2) Connect the configured UART (see above) to your serial PC communication port.
A straight 1:1 cable connection has to be used.
3) Start the tool "Fujitsu Flash MCU Programmer" software and make the settings:
Select Crystal
Open Source
(MHX-File)
Start
programming
UG-960019-11
SK-96380-120PMC User Guide
Chapter 5 Programming the internal Flash memory
Setting Description
UART
1-2
2-3
1-2
2-3
1-2
2-3
1-2
2-3
Table 5-3: Jumper Settings for reset signal
DIP-Switch S1
Set Device Type
MB96F387R/Y
4 MHz
Application.MHX
DTR signal of X5 is used as reset source
RTS signal of X5 is used as reset source
DTR signal of X9 is used as reset source
RTS signal of X9 is used as reset source
LIN-UART 0 (X5) is used to generate reset
LIN-UART 2 (X9) is used to generate reset
No negation for the DTR/RTS signal
DTR/RTS signal is negated
MD0 MD1 MD2 nc
ON
OFF
1 2 3 4
Select COM Port
- 28 - © Fujitsu Microelectronics Europe GmbH