Synchronous Mode - Fujitsu SK-96380-120PMC User Manual

4) After programming the Flash-device, switch off the power supply and set back the
mode according to the usage of the application, e.g.:
DIP-Switch S1
(RUN Mode)
5) Power on the board. The user application is started directly.

5.2 Synchronous Mode

In order to program the Flash-ROM synchronously special third-party soft- and hardware has
to be used, e.g. GALEP-4 from www.conitec.de. This tool is not available for free.
A dedicated Flash programming socket (X4) is provided on the evaluation-board for direct
connection to this programmer.
X4: Flash programming socket
Note:
Please open the jumpers JP37 (SIN2) and JP39 (SOT2) in order to avoid that the
synchronous programming tool drives against the on-board RS232 transceiver!
© Fujitsu Microelectronics Europe GmbH
SK-96380-120PMC User Guide
Chapter 5 Programming the internal Flash memory
MD0 MD1 MD2 nc
1 2
Figure 5-1: Flash Programming Socket
- 29 -
ON
OFF
3 4
n/c 1 2 n/c
MD0 3 4 n/c
RST 5 6 SIN2
SOT2 7 8 SCK2
VCC 9 10 GND
UG-960019-11