Turn On/Off The Power Of The Unit; Turn On The Power Of The Unit; Turn Off The Power Of The Unit - Panasonic WJ-ND300 Installation Manual

TURN ON/OFF THE POWER OF THE UNIT

Turn on the Power of the Unit

1. Insert the power plug to an outlet (120 V AC, 60 Hz)
Note: Make sure the power source is 120 V AC, 60 Hz.
2. Turn on the POWER switch on the rear of the unit.
The OPERATE indicator will light and the system check
(checking the system and hard disk) will start.
The "WJ-ND300" indication will be displayed on the
LCD at startup, and the "Initializing" indication will be
displayed while startup. Then, the "System Checking"
indication will be displayed while checking the system.
When the system check is complete, the time and date
display (standby display) will be displayed on the LCD.
Startup display
Time and date display (Standby display)
Important:
When using the optional extension unit (WJ-HDE300
series), turn on the power of this unit after turning on the
power of all extension units.

Turn off the Power of the Unit

To shutdown the unit, do the following.
1. When the manual recording is being performed,
stop the recording.
Click the button in the [REC] box displayed when the
[HDD] tab is selected.
The button and the
Click the button to stop manual recording.
Refer to the Setup Instructions (PDF) for details.
When playing back recorded pictures, stop the play-
back.
Click the button displayed when the [HDD] tab is
selected.
Refer to the Setup Instructions (PDF) for details.
2. Turn off the POWER switch on the rear of the unit.
Turn off the power of the unit after confirming that all the
HDD access indicators are off.
Important:
• Detach the plug from the outlet if not operating the unit
for a length of time.
• When the unit has not been used for a certain period,
turn on the power of the unit (approximately once a
week), and perform recording/playback to prevent
interferences with functions.
button will be displayed.
27