Panasonic WJ-ND300 Installation Manual page 32

Network disk recorder

Hide thumbs Also See for WJ-ND300:

Table of Contents

Shift the display on the LCD using the arrows button (C and D).

Important:

When the HDD safety mode is activated, the power of the all HDDs will be off. (Recording and playback will be forcibly

canceled.)

Execute Each Maintenance Function

1. Press the [SET] button after selecting "YES" on the desired maintenance function display.

The message "ACCEPT" will be displayed on the LCD when the [SET] button is pressed after moving the underscore mark

below "YES" using the arrows button (A or B).

When the [SET] button is pressed after selecting "NO", returns to the previously displayed menu.

2. Press the [SET] button after selecting "YES" when "ACCEPT" is displayed.

The power of all HDDs will be turned off automatically and each menu item will be carried out when the [SET] button is

pressed after moving the underscore mark below "YES" using the arrows button (A or B).

The unit will restart when "RAID5", "SINGLE", "RECOVERY" or "INIT." is carried out.

The power of all HDDs will be turned off when the "HDD safety mode" is activated.(It takes approx.30 sec until the power is

turned off.) When the power of the HDDs is turned off, the unit can be installed in the rack without turning the power of the

unit off, and HDD replacement becomes possible. Consult your dealer for HDD replacement.

When the [SET] button is pressed after selecting "NO", the previous display will appear on the LCD.

[SET]

[ESC]

C Arrows buttons D

Table of Contents