Sanyo PDG-DXL2000 Service Manual page 17

Mechanical Disassembly
b Ballast Board and Thermal Switch(SW902) removal
1. Remove 2 screws A(M3x6) to remove Side lamp shield.
2. R emove 4 screws B(M3x8) to remove the Lamp house frame.
3. R emove 2 screws C(T3x8) to remove the Ballast board, remove 1 screw
D(T3x8) to remove the Trigger box , remove 2 screws E(M3x6) to remove
the Ballast socket.
Side lamp
shield
e
e
B
B B
B
Fig.5
A
SW902
A
Thermal switch
(M3x10)x1
Lamp house
frame
D
C
C
Ballast board
Note on mounting the thermal switch (SW902)
SW902
Thermal switch
Thermal switch
holder
-17-
Thermal switch
holder
Socket
Trigger box
Put the thermal switch on the
holder and slide it in the arrow
direction and then tighten the
screw to fix the thermal switch.