Kenwood TK-290 Service Manual page 9

TK-290
6. Key Functions
You can use these features, using the programming soft-
ware (KPG-38D). Selector function is selectable channel se-
lect or group select.
The functions for Toggle switch are listed page 8 (Fig. 2).
Right position is active for programmed function on toggle
switch except "group select".
The functions for the top key are listed page 8 (Fig.2).
Hold action and shift action are programmable.
The functions for side key are listed page 8 (Fig.2). Hold
action and shift action are programmable.
The functions for microphone key are listed page 8
(Fig.2). Hold action is programmable.
6-1. No Function
Sounds error operation beep, and no action will occur.
Use this function when the transceiver is required to be
more simple operated.
6-2. AUX.
This function can be programmed when the voice scram-
bler board is not installed.
If this key is pressed, "AUX" icon lights on the LCD and
AUX port which is inside of the transceiver turns to the high
level. If pressed again, the "AUX" icon goes off and the
AUX ports turns to the lower level.
6-3. Channel Down
If this key is pressed once, the channel number de-
creases by one step. If this key holds down for 500ms (ap-
proximate), the channel number decreases continuously.
This key works as the squelch level adjuster in a squelch
level adjust mode. This key works as the OST (operator se-
lectable tone) number selector in the OST mode. This key
works as the SCR (voice scrambler) code selector in the
voice scrambler code select mode.
6-4. Channel Up
If this key is pressed once, the channel number increases
by one step. If this key holds down for 500ms (approxi-
mate), channel number increases continuously.
This key works as the squelch level adjuster in squelch
level adjust mode. This key works as the OST (operator se-
lectable tone) number selector in the OST mode. This key
works as the SCR (voice scrambler) code selector in the
voice scrambler code select mode.
6-5. Channel Name
This key switches the LCD display between the group/
channel number and the group/channel name.
6-6. Delete/Add
This key switches the currently displayed channel be-
tween "Delete" and "Add".
The "Add" channel contained in the scan sequence, and
"Delete" channel is not contained. In the scan mode, this
key switches the channel delete or add temporarily.
8
OPERATING FEATURES
Aux
Channel Down
Channel Name
Channel Select
Channel Up
Delete/Add
Emergency Call
Group Down
Group Scan
Group Select
Group Up
Home Channel
Invert Display
Key Lock
Lamp
Low Power
Monitor
Monitor Momentary
No Function
Operator Selectable
Tone
Operator Selectable
Priority 1
Operator Selectable
Priority 2
Scan
Scrambler
Shift
SP Attenuation
Squelch Level
Squelch OFF
Squelch Momentary
Talk Around
1 This function can be selected when the scrambler board has not
2 This function can be selected when the ANI board has been in-
3 This function can be selected when the scrambler board has
Note : If "Shift" is pregrammed onto one of the PF keys or the
toggle switch, the remaining PF keys can be programmed with two
different functions. If "Shift" is programmed onto a PF key and the
toggle switch, an error will occur and the function will not operate.
Function Name Selector
1
2
3
been installed.
stalled.
been installed.
Fig. 2 Programmable functions
Toggle PF Keys Speaker/
Switch Microphone
PF Keys