Panasonic NR-B32FE2 Service Manual page 42

b. Remove Three screws that are fixation of Hinge Top
R, pull the connector out through the hole of Hinge
Top R.
CAUTION
• Be careful not to forcibly bend when the connector is
through the hole of Hinge Top R. Because it might be
cause to wire cut or connector damage.
• Please do removing and installation work of Hinge
Top R by two persons, the person who has Hinge Top
R and the person who has Door A'ssy PC, in total.
Because it might be cause of dropping accident of
Door A'ssy PC.
4. Remove Door A'ssy PC from Hinge Center R while lifting
the door.
11.8.2. Remove Door A'SSY FC
1. Remove Hinge Center R
a. Open Door A'ssy FC, and remove two screws that are
fixation of Hinge Center R.
b. Remove Hinge Center R and Shim Hinge FCT.
c. Remove Cap Hinge Pin FCT.
2. Remove Door A'ssy FC from Hinge Bottom R while lifting
the door.
3. Remove Hinge Bottom R
• Remove two screws that are fixation of Hinge Bottom R.
• Remove Hinge Bottom R.
11.8.3. Exchange Stopper Door & Latch
Door
1. Exchange Stopper Door & Latch Door of Door A'ssy FC.
a. Turn the Door A'ssy FC upside down first. Remove the
two screws that are fixation of Latch Door R of under
side of Door A'ssy FC, then remove Stopper Door and
Latch Door R.
(Stopper Door and Latch Door R are disused.)
b. Put Latch Door L upon Stopper Door L, fix securely on
left side of bottom of Door A'ssy FC by the two screws
that were removed above (1).
2. Exchange Stopper Door & Latch Door of Door A'ssy PC.
• Do in the same work as before "Exchange Stopper Door
& Latch Door of Door A'ssy FC".
42