Error Messages; Using The Security Function Of The Tablet Keys; Setting The Supervisor Password; Setting The User Password - Fujitsu LIFEBOOK T904 Operating Manual

Hide thumbs Also See for LIFEBOOK T904:
Table of Contents

Advertisement

Security functions

Error messages

Error messages
In this chapter you will find the error messages which are generated by the
mainboard and the SmartCard reader.
Error
Boot access denied
Check your
SmartCard
SmartCard reader
FAILURE
Non-authorised
SmartCard
SystemLock
installation
FAILED:
The SmartCard is
blocked.
Enter the PUK:

Using the security function of the tablet keys

If you have allotted a supervisor and/or user password in the form of tablet key combinations as
described below, you can use the tablet keys to enter this when you start your device.

Setting the Supervisor password

► Select Start - Run.
► Enter the following at the command line: C:\Program Files\Fujitsu\Security
Panel Application\Supervisor\FJSECS.EXE.
► Confirm with
Enter
► Follow the instructions on the screen.

Setting the User password

► Select Start - All Programs.
► Select Security Panel Application – Security Panel Application.
► Follow the instructions on the screen.
78
Cause
The SmartCard has no access rights to the system.
The SmartCard is either inserted incorrectly or it is not a suitable SystemLock
SmartCard.
An error has occurred on the serial port to the SmartCard reader. If this error
occurs frequently, the connection between the SmartCard reader and the
mainboard must be checked, or the SmartCard reader must be replaced.
While the error is present, access to the system is blocked.
The SmartCard cannot be used on this device. The SmartCard has been
configured for a different device.
An error occurred while installing SystemLock. Do not switch off the device,
insert the "BIOS Flash diskette" instead.
Perform a BIOS update and try the installation process again.
You have exceeded the maximum allowed number of incorrect PIN entries.
The SmartCard is blocked. Enter the administrator PUK to re-activate the
SmartCard. You must then enter a new User PIN to restart the system.
.
Fujitsu

Advertisement

Table of Contents
loading

Table of Contents