Front Bezel Security - HP EliteDesk 705 G2 MT Hardware Reference Manual

Front bezel security

The front bezel can be secured in place by installing a screw through the front of the chassis into the front
bezel.
1. Remove/disengage any security devices that prohibit opening the computer.
2. Remove all removable media, such as compact discs or USB flash drives, from the computer.
3. Turn off the computer properly through the operating system, then turn off any external devices.
4. Disconnect the power cord from the power outlet and disconnect any external devices.
CAUTION:
the system is plugged into an active AC outlet. You must disconnect the power cord to avoid damage to
the internal components of the computer.
5. Remove the computer access panel.
6. Install a 6-32 screw through the front of the chassis and into the screw hole located below the center
bezel release tab.
7. Replace the computer access panel.
8. Reconnect the power cord and any external devices, and then turn on the computer.
9. Lock any security devices that were disengaged when the access panel was removed.
34 Chapter 2 Hardware upgrades
Regardless of the power-on state, voltage is always present on the system board as long as