Safety/Instruction Decals - Toro 38518 Operator's Manual

• Before adjusting, cleaning, repairing, and
inspecting the snowthrower, and before
unclogging the discharge chute, stop the
engine, remove the key, and wait for all
moving parts to stop.
• Use a stick, not your hands, to remove
obstructions from the discharge chute.
• Before leaving the operating position, stop the
engine, remove the key, and wait for all moving
parts to stop.
• Do not wear loose-fitting clothing that could get
caught in moving parts.
If a shield, safety device, or decal is damaged,
•
illegible, or lost, repair or replace it before
beginning operation. Also, tighten any loose
fasteners.
• Do not smoke while handling gasoline.
• Do not use the snowthrower on a roof.

Safety/Instruction Decals

Important: Safety and instruction decals are located near areas of potential danger. Replace damaged decals.
60-9480
61-4790
104-2767
104-2775
3
• Do not touch the engine while it is running or
soon after it has stopped because the engine
may be hot enough to cause a burn.
• Perform only those maintenance instructions
described in this manual. Before performing any
maintenance, service, or adjustment, stop the
engine, remove the key, and disconnect the wire
from the spark plug. If major repairs are ever
needed, contact your Authorized Service Dealer.
• Do not change the governor settings on the
engine.
• When storing the snowthrower for more than 30
days, drain the fuel from the fuel tank to prevent a
potential hazard. Store fuel in an approved fuel
container. Remove the key from the ignition
switch before storing the snowthrower.
• Purchase only genuine Toro replacement parts
and accessories.
3351-836 Rev A
104-4135