Spray Prot Monitor - Toro 41163 Operator's Manual

Fresh Water Tank
The fresh water tank is located at the front, left side of the
tank (Fig. 25). It supplies you with a source of fresh water
for you to wash chemicals off of your skin, eyes, or other
surfaces in the case of accidental exposure. Always fill the
fresh water tank with clean water before handling or
mixing any chemicals.
To open the fresh water tank spigot, turn the lever on the
spigot.
1
2
Figure 25
1. Filler cap
2. Fresh water tank
Rinse Tank
The rinse tank is located at the front, right side of the tank
(Fig. 26). If you install the optional Rinse Kit, you can fill
this tank with fresh water and automatically rinse the tank.
1
Figure 26
1. Rinse tank (for use with the optional rinse kit)
3
3. Spigot
23

Spray Prot Monitor

The Spray Pro monitor displays and monitors various
system performance data such as vehicle speed and
application rates. It does not control the application rate.
The monitor has an LCD screen that displays the data you
select, a selection dial, and 4 buttons for calibrating the
monitor (Fig. 27).
2
3 3
Figure 27
1. LCD screen
2. Selection dial
Selection Dial
The selection dial contains the following positions:
• Speed
Displays the ground speed in miles per hour (if the
Units of Measure is set to US or TURF) or kilometers
per hour (if the Units of Measure is set to SI).
• Units of Measure
Displays the current measurement unit selection as
follows:
– US (United States measuring system)
– SI (metric system)
– TURF (as US but the volumes are in US gallons per
1000 sq ft instead of US gallons per acre)
1
3 3
3. Calibration buttons