2. Remove the key from the ignition switch. You must
open both bypass valves.
3. Lift the seat.
4. Rotate each by-pass valve counterclockwise 1 turn
(Figure
22).
Note: This allows hydraulic fluid to bypass the pump,
enabling the wheels to turn.
Important: Do not rotate the bypass valves more
than 1 turn. This prevents the valves from coming
out of the body and causing fluid to run out.
5. Disengage the parking brake before pushing the
machine.
Changing to Machine Operation
1. Rotate each bypass valve clockwise 1 turn and hand
tighten them
(Figure
Note: Do not over tighten the by-pass valves.
2. Torque the valves approximately 8 N∙m (71 in-lb) as
shown in
Figure
22.
Note: The machine does not drive unless the bypass valves
are turned in.
1. Bypass valves
Hauling the Machine
•
Use care when loading or unloading the machine into a
trailer or a truck.
•
Use full-width ramps for loading the machine into a
trailer or a truck.
•
Tie the machine down securely using straps, chains, cable,
or ropes. Both front and rear straps should be directed
down and outward from the machine.
22).
Figure 22
24