Table of Contents
Advertisement
pressure must not exceed 276 kPa to
prevent damage to the filter element.
•
Dry the filter element using warm,
flowing air (71° C) max), or allow the
element to air dry. Do not use a light bulb
to dry the filter element because damage
could result.
Compressed Air Method
•
Blow compressed air from inside to the
outside of dry filter element. Do not
exceed 689 kPa to prevent damage to the
element.
•
Keep the air hose nozzle at least 5 cm
from filter and move the nozzle up and
down while rotating the filter element.
Inspect for holes and tears by looking
through the filter toward a bright light.
5.
Inspect the new filter for shipping damage.
Check the sealing end of the filter. Do not
install a damaged filter.
6.
Insert the new filter properly into the air
cleaner body. Make sure the filter is sealed
properly by applying pressure to the outer rim
of the filter when installing. Do not press on
the flexible center of the filter.
7.
Reinstall the cover and secure the latches.
8.
Reset the indicator if it is showing red.
Engine Oil and Filter
Change the oil and filter after the first 50 hours of
operation; thereafter change the oil after every 50
hours and the oil filter after every 100 hours.
1.
Remove the drain plug and let oil flow into a
drain pan. When oil stops, install the drain
plug.
Maintenance
1. Engine oil drain plug
2.
Remove the oil filter. Apply a light coat of
clean oil to the new filter seal before screwing
it on. DO NOT OVER TIGHTEN.
3.
Add oil to the crankcase.
1
1. Engine oil filter
Fuel System
Fuel Tank
Drain and clean the fuel tank every two years. Also,
drain and clean the tank if the fuel system becomes
contaminated or if the machine is to be stored for an
extended period. Use clean fuel to flush out the
tank.
Fuel Lines and Connections
Check lines and connections every 400 hours or
yearly, whichever comes first. Inspect for
deterioration, damage, or loose connections.
– 29 –
Figure 34
Figure 35
1
Advertisement
Table of Contents
