Cisco TelePresence SX20 Codec
Introduction
Conference commands
xCommand Conference DoNotDisturb Activate
This command switches on the Do Not Disturb mode, and the Timeout parameter allows you to
control when it is switched off again. When Do Not Disturb is switched on, all incoming calls are
rejected and registered as missed calls. The calling side receives a busy signal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Activate [Timeout: Timeout]
where
Timeout: Integer (1..1440)
Set the number of minutes before Do Not Disturb is switched off. If not set, Do Not
Disturb times out after 1440 minutes (24 hours).
xCommand Conference DoNotDisturb Deactivate
Switch off the Do Not Disturb mode. When Do Not Disturb is switched off incoming calls come
through as normal.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference DoNotDisturb Deactivate
xCommand Conference SpeakerLock Release
Releases locked speaker set by xCommand Conference SpeakerLock Set. Default voice
switching is switched back on.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Release
SX20 Codec API Reference Guide CE8.1, APRIL 2016.
D15316.03
About the API
xConfiguration
xCommand
xCommand
xCommand Conference SpeakerLock Set
For manually locking one of the speakers to the prominent speaker position. This overrides the
default voice switching.
Requires user role: ADMIN, USER
USAGE:
xCommand Conference SpeakerLock Set Target:
where
Target: local/remote
Identifies local or remote participant.
CallId: Integer (0..65534)
Identify CallID for the remote participant. Only relevant if Target is set to "remote".
105
API Reference Guide
xStatus
Appendices
Target
[CallId: CallId]
Copyright © 2016 Cisco Systems, Inc. All rights reserved.