Initial Setup
.
Screws
Figure 2-2: Connecting the G24
Important:
Connecting External Accessories
Replace the Developer Board cover and connect the following external connectors in the
sequence shown.
Power Supply
Caution:
Caution:
8
G24
G24
MMCX
Internal
Connector
RF Cable
G-24L Charger model customers must not use the following procedure. Refer to
"G24-LC (Charger Model)" on page C-1
Before connecting the power supply, make sure that the Developer Board On/Off
switch (located in the rear of the board, as shown in
OFF
position.
When using the Wall adapter, make sure to insert it into the Power Adapter
Connector (J210) and not to the Mini-AB USB connector (J380), as shown in
Figure 2-3, on page
G24-L Developer's Kit
Internal
Antenna
Connector
External
RF Cable
External
Antenna
Connector
for the correct procedure for this model.
9.
Figure 2-3, on page
9) is in the
September 25, 2007