Table of Contents
Advertisement
Chapter 2: Developer Board and Interfaces Description
Antenna
An antenna (internal or external) must be connected to the Developer Board for adequate GSM
reception. You must connect the G24-L to either the on-board internal antenna or to an external
antenna.
Two RF connectors on the right side of the Developer Board, labeled INT ANT and EXT ANT , are
used for setting up the antenna
(Figure
2-12).
Figure 2-12: Antenna Connectors (external)
On the inside of the Developer Board, the EXT ANT connector is connected to the G24-L and the
INT ANT
is connected to the on-board internal antenna.
September 25, 2007
G24-L Developer's Kit
21
Advertisement
Table of Contents
Troubleshooting
