Table of Contents
Advertisement
Figure 12
1. Bedbar-adjusting screw
3.
Tip the cutting unit to expose the bedknife and
reel.
Important:
Make sure that the nuts on the
back end of the bedbar-adjusting screws
are not resting on the work surface; use the
kickstand
(Figure
Figure 13
1. Kickstand
4.
Rotate the reel so that a blade crosses the
bedknife approximately 25 mm (1 inch) in from
the end of the bedknife on the right side of the
cutting unit.
Note:
Put an identifying mark on this blade to
make subsequent adjustments easier.
5.
Insert the 0.05 mm (0.002 inch) shim between
the marked reel blade and the bedknife at the
point where the blade crosses the bedknife.
6.
Turn the right bedbar adjuster clockwise until
you feel light pressure (i.e. drag) on the shim,
then back off the bedbar adjuster 2 clicks and
remove the shim.
13).
Note:
Adjusting 1 side of the cutting unit affects
the other side, the 2 clicks will provide clearance
for when the other side is adjusted.
Note:
If starting with a large gap, both sides
should initially be drawn closer by alternately
tightening the right and left sides.
7.
Slowly rotate the reel so that the same blade
g003322
that you checked on the right side is crossing
the bedknife approximately 25 mm (1 inch) in
from the end of the bedknife on the left side of
the cutting unit.
8.
Turn the left bedbar adjuster clockwise until the
shim can be slid through the reel to bedknife
gap with light drag.
9.
Return to the right side and adjust as necessary
to get light drag on the shim between the same
blade and bedknife.
10.
Repeat steps
through both gaps with slight drag, but 1 click in
on both sides prevents the shim from passing
through on both sides.
Note:
The bedknife is now parallel to the reel.
Note:
This procedure should not be needed
on daily adjustments, but should be done after
grinding or disassembly.
11.
From this position (i.e., 1 click in and shim not
passing through) turn the bedbar adjusters
clockwise 1 click each.
Note:
Each click turned moves the bedknife
0.022 mm (0.0009 inch). Do not overtighten
the adjusting screws.
12.
Test the cutting performance; refer to
the Cutting Unit (page
g191340
Adjusting the Rear Roller
1.
Adjust the rear roller brackets
desired height-of-cut range by positioning the
required amount of spacers below the side-plate
mounting flange
1. Spacer
2. Roller bracket
9
8
and
9
until the shim can be slid
7).
(Figure
(Figure
14) per the HOC Chart.
Figure 14
3. Side-plate mounting flange
Checking
14) to the
g003324
Advertisement
Table of Contents
