Table of Contents
Advertisement
Changing the basic settings
Prerequisite: The oven must be switched off.
Read the basic settings table to understand each setting.
Example in the picture: modifying the basic settings of the
operation of the short half-fan.
°
Press the
button for approx. 4 seconds until the
1.
displayed.
The display panel shows the following basic setting.
Select the required basic settings with the control knob.
2.
Automatic shut off
This oven has an automatic shut-off function. This function is
activated when no cooking time has been specified and the
configuration has not changed for a long time. This depends on
the temperature or grill power selected.
Automatic shut-off activated
The display panel turns on
Press any key to turn off the indicator. You can now begin
programming again.
Cleaning function
The cleaning function regenerates the self-cleaning surfaces
inside the oven.
The inside rear and side walls and ceiling of some ovens may
be lined with a highly porous ceramic lining. This lining absorbs
splashes produced during baking and roasting, dissolving them
while the oven is on. This cleaning system makes it possible to
regenerate self-cleaning surfaces that can not properly clean
themselves.
As an option, self-cleaning side walls can be purchased as
special accessories from the Technical Assistance Service, by
quoting part number 680828 and 680829.
The clean function can be used when the oven is equipped with
a self-cleaning back wall and self-cleaning side walls. This
function intensifies the regeneration process for the self-
cleaning walls.
Changing the basic settings
Once the side walls have been installed, activate the clean
function using the basic settings. See the Basic settings
chapter to find out how to do this.
°
"‰
. The oven will pause operation.
Press the
3.
4.
Change the basic setting using the control knob.
symbol is
5.
Now you can change other basic settings, as described in
points 2 to 4.
6.
Press the
approximately four seconds. All changes are saved
Cancelling
%
Press the
Note: If a cooking time has been set, the oven stops heating
when this time has elapsed. The automatic shut-off is not
required.
Cleaning levels
There are three cleaning levels available.
Level
Cleaning level
‚
mild
ƒ
medium
„
intense
Before cleaning
Remove all pans and unsuitable accessories from inside the
oven.
Cleaning the oven's base and enamelled walls
Before programming the clean function, clean the surfaces
inside the oven that are not self-cleaning. Otherwise, stains will
appear that are impossible to remove.
Use a cleaning cloth and hot water with a little soap or vinegar.
If very dirty, use a fine steel scourer or a special oven cleaning
product. These must only be used when the oven interior is
cold. Do not use metal scourers or special oven cleaning
products on self-cleaning surfaces.
X
button.
°
button until the time is displayed. Wait for
button. The changes are not applied.
Duration
approx. 45 minutes
approx. 1 hour
approx. 1 hour, 15 minutes
13
Advertisement
Table of Contents
