Operation; Installing And Removing The Attachment; Transport Position - Toro 22549 Operator's Manual

Operation

Determine the left and right sides of the machine from
the normal operating position.
Installing and Removing
the Attachment
Refer to the Operator's Manual for the traction unit for
the installation and removal procedure.
Important:
Before installing the attachment,
position the machine on a level surface, ensure
that the mount plates are free of any dirt or debris,
and ensure that the pins rotate freely. If the pins
do not rotate freely, grease them.
Important:
Before you operate the attachment
with the Outcross machine, refer to the machine
Operator's Manual for load limits and proper
ballast requirements.
Note:
Always use the traction unit to lift and move
the attachment.
WARNING
If you do not fully seat the quick-attach
pins through the attachment mount plate,
the attachment could fall off the machine,
crushing you or bystanders.
Ensure that the quick-attach pins are fully
seated in the attachment mount plate.

Transport Position

When transporting a load, keep the attachment as
close to the ground as possible, no more than 15 cm
(6 inches) above the lowest position. Tilt it rearward to
keep the load level.
1. No more than 15 cm (6
inches) above the lowest
position
7
Figure 5
2. Tilt the load rearward
g272288