Filter Reset; Storage; Troubleshooting - Philips 4000i Series User Manual

Filter reset

You can replace the filter even before filter replacement alert (
the screen� After replacing a filter, you need to reset the filter lifetime counter
manually�
1
Touch the power
unplug from power socket�
2
Put the power plug in the power socket�
3
Within 15 seconds after power on, touch and hold
3 seconds to reset the filter lifetime counter (fig y)�

6 Storage

1
Turn off the air purifier and unplug from the power socket�
2
Clean the air purifier, particle sensor and the surface of the filter (see
chapter "Cleaning and maintenance")�
3
Let all parts air dry thoroughly before storing�
4
Wrap the filter in air tight plastic bags�
5
Store the air purifier, filter in a cool, dry location�
6
Always thoroughly wash hands after handling the filter�
7

Troubleshooting

This chapter summarizes the most common problems you could encounter
with the appliance� If you are unable to solve the problem with the information
below, contact the Consumer Care Center in your country�
Problem
The appliance
does not work
even though it is
plugged in�
button for 3 seconds to turn off the appliance and
Possible solution
• Check if the back cover is properly installed�
• The filter replacement alert has been on continuously
but you have not replaced the corresponding filter� As a
result, the appliance is now locked� In this case, replace
the filter and long press
counter�
) displays on
and button for
to reset the filter lifetime
EN
13