Table of Contents
Advertisement
Spreader Pattern Adjustment
If the spread pattern is skewed or dispensing too light
or too heavy to 1 side
as follows:
Figure 19
1. Heavy to left side
2. Move ramp pattern to
shaded position
Note:
Do not adjust the ramps to split product flow.
Use only the front or rear ramp positions as shown.
1.
Unlock the spreader pattern control knob by
turning it counterclockwise 90 degrees.
Figure 20
1. Spreader pattern control
knob
To adjust when the grass seed pattern is heavy:
•
To the left side, slightly pull the control handle
rearward.
•
To the right side, slightly push the control
handle forward.
2.
Lock the spreader pattern control by turning the
control knob clockwise 90 degrees.
(Figure
19), adjust the gate
3. Heavy to right side
2. Control handle
Operating Tips
Overseeding
Important:
Do not put down more seed than
recommended by the seed company. Overseeding
can cause the grass to be too thick and become
susceptible to fungus.
Note:
The machine seeds at the same rate going
both forward and rearward.
Note:
If there is excessive thatch, it may be
necessary to remove the thatch prior to seeding.
Removing the Spreader
g025543
Attachment
1.
Shut off the engine, remove the key, wait for all
moving parts to stop, and engage the parking
brake.
2.
Unplug the spreader accessory harness
9).
3.
Disconnect the cable ball joint from the control
lever
(Figure
mount bracket.
4.
Remove and retain the hitch pin from the
receiver
(Figure
5.
Remove the hopper assembly, control cable,
and accessory harness.
Note:
All other spreader attachment
components may stay mounted on the machine.
Make sure components are secure and away
from moving parts.
g207877
17
6). Loosen the knob on the cable
4)
(Figure
Advertisement
Table of Contents
