Advertisement
When not in use, disconnect from the air supply, remove the staples from the magazine and store cased in a safe, dry, childproof
9
location.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that
‰
may occur. It must be understood by the operator that common sense and caution are factors which cannot be built into
this product, but must be applied by the operator.
2. INTRODUCTION
Powerful, compact cordless nail and staple gun can drive up to 50mm 18G nails or 40mm 18G staples into wood, without compressed air or
mains power supply. Robust composite housing incorporates two LED lights for use in low light areas. Selectable single or contact firing allows
use for different applications. Features an adjustable drive depth wheel for accurate results. Safety trigger device prevents accidental firing of
nails or staples. Requires compatible 20V battery and mains charger, sold separately.
3. SPECIFICATION
Model No. ............................................................. CP20VNG
Battery ................... 20V 2Ah - 6Ah Lithium-ion (not included)
Consumable parts:
CP20VBP2 - 2Ah Battery, CP20VBP4 - 4Ah Battery,
CP20VBP6 - 6Ah Battery
Nail capacity ..............................................10-50mm 18SWG
Replacement parts
............................. CP20VMC - Mains Charger (not included)
Vibration/uncertainty ................................... 1.39m/s²/1.5m/s²
Noise Power/Pressure ........................................ 91/80 dB(A)
4. OPERATION
The machine is intended for tacking of cardboard, insulating material, fabric, foils, leather and similar materials on surfaces of wood
or materials similar to wood. The machine is not suitable for the attachment to brick, concrete etc.
4.1.
LED INDICATOR
4.1.1.
The LED will be on to indicate status of power tool and charger:
fig.2
LED RED flashing: Jam
LED RED: Low battery
LED GREEN flashing: Overheat
LED Green: No nails
4.2.
INSERTING AND REMOVING THE BATTERY
4.2.1.
Insert the battery pack into the grip until it clicks in place.
4.2.2.
To remove the battery pack, press the lock button to pull the pack out of the machine.
LED LIGHTING
4.2.3.
Two Led lights one in each side can be turned on when the machine is working, fig.1.
4.3.
CHECKING THE CONTACT TRIP MECHANISM
4.3.1.
Remove all staples or nails from the magazine.
4.3.2.
Press the safety nose/contact pin and pull the trigger. The safety nose/contact pin and the trigger should move freely.
4.3.3.
Reload the staples or nails to the magazine.
DO NOT use the tool if the safety nose/contact pin cannot move freely.
8
4.3.4.
Place the contact pin on the workpiece and press the machine without pulling the trigger, the machine should not fire ; Take the
machine from the workpiece, the contact pin should spring back automatically. Pull the trigger, The machine should not fire.
4.4.
INSERTING STAPLES OR NAILS INTO THE MAGAZINE
NOTE: The number of staples or nails left in the magazine can be read using the viewing window.
WARNING! REMOVE BATTERY PACK FROM THE TOOL.
‰
WARNING! Keep the tool pointed away from yourself and others when loading fasteners. Failure to do so could result in
‰
possible serious personal injury.
WARNING! Never load fasteners with the workpiece contact or trigger activated. Doing so could result in possible serious
‰
personal injury.
© Jack Sealey Limited
fig.1
Original Language Version
CP20VNG
Issue 2 (2,3) 24/05/21
Advertisement
