Advertisement
4.4.1.
Press the release button and pull out the magazine.
4.4.2.
Tilt the tool and place nails/staples into the track of the magazine channel.
4.4.3.
Make sure that the fasteners are placed correctly, see fig's.3 and 4.
a) Staples are placed against the profiled side of the rail, the crown of the staple is in the uppermost part of the magazine (legs are
facing away from the body of the tool).
b) Nails are placed against the profiled side of the rail, with the points of the nails facing downwards.
4.4.4.
Close the magazine cover until it engages with the release button.
NOTE: The number of staples or nails left in the magazine can be seen using the magazine indicator.
Reattach battery pack to tool.
WARNING!: DO NOT place fasteners of different length. DO NOT place staples and nails mixed together.
‰
A. Loading staples:
fig.3
4.5.
INSTRUCTIONS FOR USE
WARNING! Keep the tool pointed away from yourself and others when loading fasteners. Failure to do so could result in
‰
possible serious personal injury.
WARNING! When loading the tool's magazine, check that the nail tips contact the wear rail and slide smoothly against the surface of the
‰
magazine. If the nails are not loaded properly, the tool will misfire and nails can be deflected, causing the tool to react in an unexpected
manner, and damage the tool.
4.5.1.
Prior to operation make sure your battery pack is fully charged.
4.5.2.
Check whether the fasteners are placed in the magazine correctly.
4.6.
NAILING OR STAPLING
WARNING! This tool has either selective actuation for contact actuation or continuous contact actuation by actuation mode
‰
selectors or is a contact actuation or continuous actuation contact tool and has been marked with the symbol at the start of this
manual (*). If using this tool in selective actuation mode, always ensure it is in the correct actuation setting.
4.6.1.
Hold handle firmly with magazine flat to work piece forming a 90° angle.
4.6.2.
Two modes of firing: Single Firing and Contact Firing.
4.7.
SINGLE FIRING MODE SEE FIG.5:
Push the single/contact firing switch, see fig.2, to left side, it is on Single Firing mode. Single Firing is good for precision
placement.
fig.5
The safety contact pin must be depressed before the trigger is squeezed.
© Jack Sealey Limited
B. Loading nails:
Depress the safety contact pin
against the work piece.
Original Language Version
fig.4
Squeeze the trigger to fire the staple
or nail ; Release the trigger and
safety contact pin after firing.
CP20VNG
Issue 2 (2,3) 24/05/21
Advertisement
