Frigidaire FEB30XPFSA Owner's Manual page 10

WARM & SERVE DRAWER INSTALLATION INSTRUCTIONS
INSTALLATION AND SERVICE MUST BE PERFORMED BY A QUALIFIED INSTALLER.
IMPORTANT: SAVE FOR LOCAL ELECTRICAL INSPECTOR'S USE.
READ AND SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
FOR YOUR SAFETY: Do not store or use gasoline or other flammable vapors and liquids in the
vicinity of this or any other appliance.
GENERAL INFORMATION
The Warm & Serve Drawer can be used:
• As a stand alone appliance
• As a combination Warm & Serve Drawer with a 30" (76 cm) built-in oven mounted above
IMPORTANT: The warmer drawer must be installed on a leveled surface from left to right, rear to front.
NOTE: A 60" (152 cm) long cable is supplied with the
Warm & Serve Drawer.
Stand Alone Installation
A. HEIGHT B. WIDTH
9 7 " (25 cm) 30" (76,2 cm)
/
8
D. CUTOUT
HEIGHT
Min. 8 3 " (21,3 cm) 28
/
8
Max. 8 5 " (21,9 cm) 28
/
8
Warm & Serve Drawer Dimensions
C. DEPTH
24 5 " (62,5 cm)
/
8
E. CUTOUT F. CUTOUT
WIDTH DEPTH
1 " (72,4 cm) 24" (61 cm)
/
2
3 " (73 cm)
/
4
IMPORTANT: The Warm & Serve Drawer runs off a
single phase three-wire 120 volt, 60 hertz, AC only
electrical supply with ground.
Combination Warm & Serve Drawer/
30" (76 cm) Built-in Oven Installation
A. HEIGHT B. WIDTH
40" (101,5 cm) 30" (76,2 cm)
D. CUTOUT
HEIGHT
Min. 38 1 " (97,8 cm) 28
/
2
Max. 39" (99,1 cm) 28
10
C. DEPTH
24 5 " (62,5 cm)
/
8
E. CUTOUT F. CUTOUT
WIDTH DEPTH
1 " (72,4 cm) 24" (61 cm)
/
2
3 " (73 cm)
/
4