Bosch Quigo Green Original Instructions Manual page 13

measuring tool is held freely in the hand, the laser lines will continuously
flash slowly and the measuring tool will work without automatic levelling.
The laser lines remain switched on, but the two intersecting lines will no
longer necessarily be perpendicular to each other. To make sure that the two
laser lines are still perpendicular to one another, position the measuring tool
at an angle of 90° to the wall.
In case of ground vibrations or position changes during operation, the meas-
uring tool is automatically levelled again. Upon re-levelling, check the posi-
tion of the horizontal or vertical laser line with regard to the reference points
to avoid errors by moving the measuring tool.
Working Advice
Only the centre of the laser line must be used for marking. The width
u
of the laser line changes depending on the distance.
Attaching using the holder (see figure A)
Using the holder (16), you can attach the measuring tool to various objects
up to 10 to 60 mm thick, e.g. to vertical or horizontal boards or pipes.
Loosen the fastening screw (15) of the holder, position the holder in the de-
sired location and retighten the fastening screw.
Place the measuring tool with the tripod mount (8) on the 1/4" screw (13)
of the holder and tighten it to secure it on the holder applying moderate
force. Do not tighten the measuring tool firmly as this could cause damage.
Roughly align the holder before switching on the measuring tool. To do this,
loosen the locking screw (14). Move the measuring tool into a horizontal po-
sition at the required height (with the tripod mount (8) facing down).
Retighten the locking screw.
You can also mount the measuring tool on the holder using the adapter
plate (3).
Working with the Tripod (Accessory)
A tripod offers a stable, height-adjustable support surface for measuring.
Place the measuring tool with the 1/4" tripod mount (8) on the thread of the
tripod (6) or a conventional camera tripod. Tighten the measuring tool using
the locking screw of the tripod.
Roughly align the tripod before switching on the measuring tool.
You can also mount the measuring tool on the tripod using the adapter
plate (3).
Bosch Power Tools
English | 13
1 609 92A 6GR | (02.02.2021)